Table of contents
The VESA adapter is compatible with the following products from hp (hp.com): M22F, M24F, M27f, M32f.
The VESA adapter allows you to conveniently mount your HP brand monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and nuts.
If you want to mount your VESA adapter directly to the wall, use suitable screws and dowels (not included).
Here you can download the manual as a PDF
Lay your HP monitor flat on a safe and soft surface. Now remove the stand of your monitor.
Move the white clip of your HP monitor to the position shown. (Figure 1)
Figure 1
Now attach the VESA adapter to your monitor arm using the included screws. (Figure 2)
Tighten the screws firmly enough, but please remember that it is plastic.
Alternative: Wall mounting is also possible, but screws and dowels are not included.
Figure 2
Please check again if all screws are tightened properly. (Figure 3)
Figure 3
Now slide your monitor diagonally, from bottom to top into the 3idee VESA adapter. (Figure 4)
Figure 4
Please check whether the monitor is correctly locked into the VESA adapter. The monitor will be able to move in the adapter despite correct mounting. This is due to manufacturing tolerances of the monitor mount, as well as us.
Nevertheless, the safety of the adapter is guaranteed by a correct engagement of the clip.
- Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if available).
- The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC exhaust or direct sunlight in summer.
- PLA is UV resistant but not suitable for high temperatures.
- Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the VESA adapter.
- Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the performance of the VESA adapter.
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
