Table of contents
The VESA adapter is compatible with the following products from hp (hp.com): 27q.
The VESA adapter allows you to conveniently mount your HP brand monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and nuts for this purpose.
If you want to mount your VESA adapter directly to the wall, use suitable screws and dowels (not included).
Here you can download the manual as a PDF
Remove the base of your monitor.
Before we start: It is important that you pay attention to the correct order of the long mounting screw. First slide the spring washer (write with slot) and then the normal washer onto the screw. (Figure 1)
Figure 1
Insert the adapter into the screen and fix it with the long screw. (Figure 2)
Figure 2
Make sure that the screw is properly tightened and no longer protrudes.
Attention: Tighten the screw with feeling! The plastic could otherwise break
(Figure 3)
Figure 3
Mount the adapter on the VESA monitor arm or directly on the wall.
Attention: Tighten the screw with feeling! The plastic could otherwise break
(Figure 4)
Figure 4
- Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if available).
- The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC exhaust or direct sunlight in summer.
- PLA is UV resistant but not suitable for high temperatures.
- Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the VESA adapter.
- Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the performance of the VESA adapter.
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
