Table of contents
The VESA adapter is compatible with the following Dell products (dell.com): S2419HM, S2719DM, S2719DC.
With the VESA adapter, you can easily mount your DELL brand monitor to a monitor arm with a VESA hole pattern (75 x 75mm). Use the included screws and nuts.
If you want to mount your VESA adapter directly to the wall, use suitable screws and dowels (not included).
Here you can download the manual as a PDF
First, mount the stand of your Dell monitor. Remove the 2 screws at the bottom. (Figure 1)
Figure 1
Now plug the 3idee VESA adapter onto the mount on the monitor. (Figure 2)
Note: Please note the marking above / below!
Figure 2
Now screw the 2 small, long screws into the VESA adapter from below. (Figure 3)
Figure 3
Now you can hold the monitor with one hand and attach it to your VESA arm with the other hand by tightening the 4 screws from behind. (Figure 4)
Figure 4
Please check again if all screws are tightened properly. (Figure 5)
Figure 5
- Make sure that all screws are tight and that the monitor audibly clicks into place during installation (if available).
- The material of the adapter is not heat resistant. Avoid direct heat around the adapter such as PC exhaust or direct sunlight in summer.
- PLA is UV resistant but not suitable for high temperatures.
- Avoid jerky movements (pulling, tearing) on the PC monitor. This can affect the performance of the VESA adapter.
- Do not subject the PC monitor to excessive loads such as leaning or pushing. This can impair the performance of the VESA adapter.
The adapter is made of high-quality polylactide (PLA) plastic. PLA is both a colorfast and UV-resistant material and has low flammability. Polylactide has a low temperature resistance of approx. 45°C-55°C and is therefore not suitable for use in the vicinity of direct heat and heat sources.
We wish you a lot of fun with your product.
Your 3idee Team
